Before connecting to any equipment follow these precautions:
· Make sure that the wires are securely attached to the connector and that no uninsulated portion of the wire is visible after the connection is made.
· Make sure that there is no strain that could pull the leads out of the LCV connector.
· Make sure that the leads will not interfere with any moving pieces of equipment and will not pull loose any wires or other connections.
To measure the voltage, connect the two voltage clip leads to the points at which the voltage is being measured.
To measure the current, place the clamp probe around the wire in which the current is being measured.
CAUTION!
Electrical connection to any type of operating equipment is Dangerous!
The LCV leads and current probe should only be connected when it has been determined that the power is off and the equipment is safe to touch.
It is suggested that you always remove the LCV voltage leads before connecting the LCV to your computer!
If you decide to connect the LCV to a voltage source while the LCV is connected to your computer, make sure to read the "Connecting the LCV to both the Computer and a Voltage Source" section for instructions.