The table below shows the different logger states that the status light can show. The interval of N seconds corresponds to the interval that you set in the LED Flash Frequency box in the Advanced Setup Window.
|
Status Light |
Logger State |
|
Flashes green 5 times in rapid succession. |
Power up. The logger will flash this sequence right after a new battery is installed. This indicates that a new battery was installed correctly and that the logger is functioning correctly. |
|
Flashes red then green, every N seconds. |
The logger is in delayed logging state. This indicates that logging has been initiated, but the first sample has not been recorded yet. This occurs when delayed logging is chosen from the Setup screen. |
|
Flashes green 4 times, 1 second apart. |
Starting to log. This indicates that the logger is starting to log the first sample. This sequence will only show when the first data sample is logged. |
|
Flashes green every N seconds. |
Logging is in progress, no alarms occurred. The data logged is within the user specified minimum and maximum values for all the channels. |
|
Flashes red every N seconds. |
Logging is in progress, high or low alarms occurred. At least one data sample logged was outside the user specified minimum and maximum values. |
|
Flashes red every half second for 10 seconds |
The logger was setup to stop logging when the door is closed, and you’ve just closed the door. Reopen the door within the 10 seconds to continue logging. When the status light stops blinking, the logging has stopped. |